Standing seam and metal panel roofing, roof repair and full replacement in Mills River. We show up when we say we will, and we clean up before we go.
Metal roofing is our specialty, but shingles, gutters, soffit and leak work all get the same attention in Mills River.
This is the work our name is attached to. Two decades of tin roofs on houses, churches, barns and additions, installed by crews who cut the trim on site instead of forcing something that almost fits.
Slate and tile take patience and matching pieces. We replace broken and slipped units and rework the flashing they hide.
If two other people have caulked it and it still leaks, call us. Most stubborn leaks turn out to be flashing, a valley, or a fastener nobody thought to check.
Porch roofs, additions and low slope sections that hold water instead of shedding it. We rework the flashing, seal the seams, and get water moving again.
Full tear off, decking checked board by board, then a new metal or shingle roof over proper underlayment. You get the price and the start date before anything comes off.
Squirrels, wasps and water all treat a soft soffit as a front door. We close it up properly instead of patching over it.
We repair what the storm actually broke. If that is one slope, we do one slope, and we will not pad an estimate to make a claim look bigger.
Repair or replace, we handle both, and we work from what the roof actually needs rather than from what an adjuster might approve.
Coatings for low slope and older metal roofs that are still sound but weathered. Washed down, refastened, primed at the rust, then coated.
The layer you never see is what keeps water out on the ugly days. We do not thin it out to save a few dollars on a bid.
Hard wind lifts shingles and works panel fasteners loose along the edges, which is exactly where the next storm gets underneath. We refasten, replace and reseal.
Churches, shops, barns and small commercial buildings. We have roofed everything from a wood shed to a steeple.
A twenty year old panel roof usually needs fasteners and sealant, not replacement. We refasten with new washers and get you another long stretch out of it.
A shingle repair should not be visible from the street. We match as close as the weathering allows and blend the new work into the old.
Most roofs somebody has called a lost cause are not one. We repair what can be repaired, and we tell you honestly when a repair will no longer hold.
New skylights set into metal or shingle roofs, with the flashing kit the roof actually calls for rather than a tube of sealant.
A limb through the roof or panels peeled back overnight needs covering now, not next week. We get it dried in first so the inside of the house stops taking damage.
We match the guard to your trees and your gutter profile, and make sure water can still get in where it is supposed to.
Buying, selling, or just want to know how many years you have left? We look, we tell you, and we do not turn it into a pitch for a roof you do not need.
Ice backs up at a cold eave and pushes water sideways under the roof. We clear it without gouging the panels or the shingles.
Here is what working with us looks like in Mills River: you call, somebody comes out and measures, and you get a written estimate with the panel or the shingle spelled out on it. If you say go, we schedule you and we show up on that day.
The crew tarps the beds, keeps the yard picked up as they go, and runs a magnet over the drive before pulling out. Small things, but they are the ones Mills River homeowners still mention a year later.
Here is what Mills River homeowners tell us makes the difference.
The same family started this company putting metal roofs on neighbors houses in 2002. It has never been sold, franchised or handed off to a call center.
Somebody comes out, measures, gets on the roof, and leaves you a written price. No charge, no obligation, and no number that expires if you do not sign today.
Standing seam and metal panel roofs are the work we are known for. Color, trim, fastening pattern — we have done hundreds and we will walk you through all of it.
A few backed out screws or a whole roof off a church — we take both. No job is too small to get the same crew and the same care.
You get a start date and we hold to it. If weather moves your job we call you, rather than leaving you watching the driveway.
The questions that come up on just about every estimate we write.
No. Estimates are always free in Mills River. We come out, measure, look in the attic if we can get to it, and leave you a written price. Nobody will push you to sign anything that day, and the number does not expire in an hour.
Sometimes. If the decking is sound and there is only one layer of shingles, a Mills River metal roof can go over the top on purlins. If there is rot underneath or two layers already on, we tear off first — and we will tell you that before you sign, not halfway through.
Most Mills River metal roof jobs land somewhere between about $12,000 and $30,000 in 2026, depending on square footage, pitch, panel type and how much tear off there is. Standing seam runs higher than exposed fastener panels. We measure before we quote, and the estimate is free.
Often, yes. Plenty of the Mills River roofs we get called to look at need flashing reworked or a section refastened, not a whole new roof. We will tell you honestly which one you are looking at, and if it is repairable we would rather repair it.
Much less than people expect. Over solid decking with underlayment under it, a Mills River metal roof sounds about like a shingle roof from inside the house. The loud tin roof people remember was screwed straight to open purlins over a barn with nothing underneath.
A typical Mills River shingle roof runs roughly $8,000 to $18,000 in 2026 for an average single family home, and more if the deck has rot or the roof is steep and cut up with dormers. We do not price off a satellite photo — somebody comes out and measures.
Real feedback from homeowners whose roofs we have worked on.
"Honest people. I asked for a quote on a whole new roof and they told me mine had another eight years in it and just needed the valleys resealed. Who does that anymore?"
"Thank you so much to the entire crew at Roofing Brothers for our amazing new tin roof! You were amazing to work with and I couldn't recommend you to others enough! Great communication, pricing, color options, efficiency, and HONESTY! If anyone needs a new roof, I highly recommend this crew! Phenomenal job."
"Called about shingles that blew off in a storm. They were out the next morning, patched it, and would not take a dime more than what the estimate said."
Roofing Brothers also serves these towns near Mills River.